Page | 10
www.outdoorrooms.com
CF-1242 AU Rev-E 8/24/15
4
Setting up your Burner
A. Burner Assembly
•
Check for damage. Do not use damaged components.
•
The burner must be replaced prior to the appliance be-
ing put into operation if it is evident that the burner is
damaged. The replacement burner assembly specified
by the manufacturer.
•
Position the assembly in the desired location. This loca-
tion must be adjacent to the gas supply line. You must
have easy access to the gas valve control knob after it
is installed and connected to the gas supply.
•
Ensure that the perimeter of the burner is evenly
supported and stable prior to installation
LP Gas Models
•
Make sure the valve is turned completely off
before installing.
•
LP installations are to be hard-plumbed using
rigid piping
only.
B. Glass Beads Installation
Spread glass out evenly over burner area. Use all glass
provided for best effect. Keep glass clear of spark to
avoid accidental blockage of gas flow.
Note:
A percentage of glass beads may arrive split in half.
This is normal. Additional beads may split after use.
This is also normal due to the physical properties of
glass.
DO NOT BURN WITHOUT GLASS
BEADS
C. Glass Guard
A protective glass guard is provided with your
burner. This protects the flame from wind.
Installation instructions are provided separate from
this user manual.
The supplied Guard is fitted for this
appliance and must be secured using the
provided fasteners around the burner and
must be in position at all times during
operation. The guard is for protection
against injury from burns or fire and must
not be removed.
DO NOT BURN WITHOUT
GLASS GUARD IN PLACE
