Page | 5
www.outdoorrooms.com
CF-1242 AU Rev-E 8/24/15
2
Getting Started
This appliance is a Decorative Gas Appliance for
OUTDOOR USE ONLY
and
MUST NOT
be used
for cooking.
Build or position the CF-1242AU burner system on
a flat and stable surface in an outdoor location such
as a patio or deck. This location must be adjacent to
the gas supply line or LP gas supply.
DO NOT
locate the appliance where it will get excessively
wet or submerged in water.
A.
Design and Installation Considerations
When planning an appliance installation, it’s necessary to
determine the following information before installing:
•
Where will the appliance be installed?
See section 3
•
Gas supply piping.
See section 5
•
Framing and finishing details.
See section 3
B.
Tools and Supplies Required
Before beginning the installation, be sure that the
following tools and supplies are at hand.
•
Gloves
•
Safety Glasses
•
Phillips screwdriver
•
Non-corrosive leak-check solution
•
Wrenches
WARNING
The Outdoor GreatRoom Company
disclaims any responsibility for, and
the warranty will be voided by, the
following actions:
•
Installation and use of any damaged
components.
•
Modification of the burner assembly
•
Installation other than as instructed
by the Outdoor GreatRoom
Company.
Any such action may cause a fire hazard
WARNING
Do
NOT
use this appliance if any part of it has
been underwater. Have an authorized service
technician inspect the appliance and replace
any part of the control system and any gas
control which has been underwater.
CAUTION
Sharp Edges
Wear protective gloves and safety glasses
during installation.
WARNING
Do not burn solid fuels in this gas appliance
C.
Inspect the Appliance and Components
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
•
Do
NOT
install damaged, incomplete,
or substitute components
Report damaged parts to your dealer.
WARNING
Asphyxiation Risk
•
This gas appliance is for outdoor use in a
well-ventilated space.
•
This unit must not be installed inside an
enclosed structure or unvented appliance
•
Carefully remove all burner
components from packaging.
•
Read all instructions before beginning
installation. Follow these instructions
carefully during installation to ensure
maximum safety and benefit.
