www.desatech.com
114144-01J
7
Manifold
Fixing Plate
Figure 7 - Attaching Manifold Fixing
Plate to Post Support
Figure 8 - Attaching Dome to Emitter
OPEraTIng
InSTruCTIOnS
WARNING: If you smell gas:
• Shut off gas to the appliance.
• Extinguish any open flames.
• If odor continues, immediately
call your gas supplier.
See safety warnings and pre-
cautions starting on the front
page of this manual for more
information.
PREPARING FOR OPERATION
1. Check heater for possible shipping dam-
age. If any is found, immediately notify the
factory.
. Follow all safety information.
3. Check and assure control knob is in the
OFF position.
4. Place propane/LP gas cylinder inside
cylinder base. Securely connect regulator
to propane/LP gas cylinder.
5. Turn cylinder valve on. Apply a soap and
water solution to connection at regulator and
cylinder. Bubbles forming show a leak.
6. In case of any leaks, turn off propane/LP
cylinder valve, undo leaking connection.
Check and clean connection. Reconnect
regulator and leak test again.
dOME ANd EMITTER
Gently lay heater assembly on its side using
one of the shipping styrofoam inserts to prop
up the top half of heater. Align holes in dome
with threaded studs in emitter cover. Secure
dome to emitter using three cap nuts. Tighten
with an adjustable wrench. Stand heater back
to upright position.
MANIFOLd FIxING PLATE ANd
POLE SUPPORT
1. Locate threaded hole underneath post
support. This hole is for mounting manifold
fixing plate (see Figure 7).
2. Align holes on manifold fixing plate with
threaded holes on pole support.
3. Make sure manifold fixing plate is facing
downward see (Figure 7).
4. Use a bolt to tighten manifold fixing plate
to post support using # Phillips head
screwdriver.
5. Turn manifold fixing plate so it will hold
manifold in place.
6. Tighten bolt so manifold fixing plate will
not move.
aSSEMBLy InSTruCTIOnS
Continued
