32
Outdoor Lifestyles by Hearth & Home Technologies, Inc. • TWILIGHT-II-MOD • 2290-900 Rev. C • 7/12
A. Remove Fixed Glass Assembly
See Section 11.F.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Glass Refractory
Install black glass refractory panels by carefully sliding
them in between the fi rebox and glass clips. See Figure
11.1.
11
11
Appliance Setup
WARNING
Delayed Ignition Risk
• Place glass rock media according to instructions.
• Do NOT place glass rock media in area in front
of pilot.
• Do NOT place glass rock media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the glass rock media
supplied with this fi replace.
Fireplace will not function properly.
Delayed ignition may occur.
F. Glass Rock Media Kit
WARNING! Choking Hazard! Keep glass rock media
out of reach of children.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Cleaning the Glass Rock Media
During shipment of the glass rock media, dust and debris
can accumulate in the rock bag. It is recommended that
the glass rock media be rinsed thoroughly with water to re-
move dust and small glass rock particles. An easy method
to clean the glass rock media is to empty the contents of
the bag into a bucket and rinse thoroughly with a garden
hose. Allow the glass rock media to dry before installing
into the fi replace.
Installation
1. Place glass rock media evenly on base pan and over
top of burner. Do not block the open area by the glass
refractory. This area must remain open for proper air
fl ow. See Figure 11.2.
USE SLOTS
TO SLIDE
REFRACTORY
INTO POSITION
Figure 11.1. Install Refractory
Figure 11.2 No Glass Rock Media in Gap
NOTICE: Care should be taken to avoid placing glass rock
media between the left and right of the media tray and the
fi rebox. Blocking this gap may cause an undesirable fl ame
appearance. See Figure 11.2.
NO MEDIA IN SHADED AREA
(BOTH LEFT AND RIGHT SIDE)
