19.
When all walls are attached
together, check alignment with the
floor. Bottom Wall Plates should sit
flush with outside of Plywood Floor.
When positioned correctly, fasten
Bottom Wall Plates to floor using
4 - 2 1/2” screws per Wall Panel.
Wall Plate
20.
Position angle cut
Rear Top Plate
(rear only) on top of wall studs so it is flush
on the inside with 2x3 Wall Plate. The Rear
Top Plate has an angle cut on the ends.
Attach by screwing down into top Wall Plate
with 4 - 2” screws.
Angle cut on ends
Rear Top Plate should be flush
with inside of Wall Framing.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com
Page 9
Caulking
Optional
- Caulking
seams will help prevent
moisture from entering at
seam.
Caulking not included in
kit.
Important-
when attaching Top
Plates, have end screws tie
into Side Walls.