FCC Statement
FCC Statement
This device comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
●
This device does not cause harmful interference.
●
This device must accept any interference received, including interference that may cause undesired
operation.
If this device is modified without authorization from Ezen, the device may no longer comply with FCC
requirements for Class B digital devices. In that a case, your right to use the device may be limited by
FCC regulations. Moreover, you may be required to correct any interference to radio or television
communications at your own expense.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This device generates, uses and radiates radio frequency energy. If it is not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device
does cause harmful interference to radio or television reception, which can be determined by turning
the device off and on, the user may take one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Reinforce the separation between the device and receiver.
●
Connect the device into an outlet on a circuit different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio or TV technician for assistance.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment should be installed and operated with a minimum distance of
20 centimeters between the radiator and your body.
The device contains LTE Module: EC25-AF (Contains FCC ID: XMR201808EC25AF).
