Maintenance - continued
Sheetmetal Care (If Applicable)
Sheetmetal Siding Cleaning and Care / Painted Surfaces
Cleaning of fabricated pre-painted coil should be done in shaded conditions or ideally on a mild,
cloudy day once to twice a month with a quality car wash or Simple Green solution. Always follow
the cleaner manufacturers instructions for care and cleaning.
When cleaning solutions are used for removal of soil, they should be used with brushing or
sponging. It may be necessary to sponge the surface while rinsing, particularly if cleaner is
permitted to air dry or is wiped dry with a chamois, squeegee or lint-free cloth.
Do not allow cleaning solutions to collect on the surfaces of horizontal surfaces or crevices. These
areas should be flushed with water and dried. Always clean coated surfaces down form the top to
bottom and follow with thorough rinsing with clean water. We recommend waxing the exterior
surface at least once a year, preferably twice a year with a quality non-abrasive wax or automotive
spray on wax. Exterior Black Streaking can be minimized with more frequent waxing. Note that
some waxes are recommended for use on certain types of surfaces. Always read and follow the
manufacturers' instruction and precautions on the container.
Summary of General Cleaning Tips
1. Always clean coated surfaces down from top to bottom. Followed by thorough
rinsing. When used in conjunction with a rubber roof. The roof should be washed
in accordance with the manufacturers procedure.
2. Strong solvent or strong cleaner concentrations can cause damage to painted
surfaces.
3. Abrasive materials such as steel wool, abrasive brushes will harm finishes.
4. Avoid temperature extremes. Heat accelerates chemical reactions and may evaporate
water from the solution. Extremely low temperature may give poor cleaning effects.
Cleaning under adverse conditions may result in streaking or staining. Ideally, cleaning
should be done in shade at moderate temperature.
5. Do not substitute a heavy-duty cleaner for recommended cleaners.
6. Never use paint removers, aggressive alkaline, acid or abrasive cleaners.
7. Follow manufacturers recommendations for mixing and diluting cleaners. Always
conduct a surface test to insure cleaning solution will not attack the painted surface.
8. Never mix cleaners.
▲
Note
Refer to Exterior Graphics Care for Fiberglass and Sheetmetal application.
81
Summary of Contents for 2013 Creek Side
Page 1: ......
