3
Safety at a Glance
1.
Environmental Considerations
•
The power supply console is not IP rated for water or dust ingress. Be aware of the working
conditions. Do not operate in rain and protect console from spray.
•
The connector on the tether is only IP rated when mated. Replace cap when storing in box
with wet tether.
2.
Operation
•
Test the Ground Fault Interrupter (GFI) prior to use. If the GFI fails return for service.
•
Do not close the lid of the power supply or block fan inlets and outlets during operation.
The unit requires air flow for proper cooling.
•
The power supply allows for continuous operation of the vehicle. Limit amount of time at
full throttle to avoid potential overheating of motor drive components.
3.
Maintenance and Upkeep
•
Do not use cracked, cut, or damaged tether.
Discontinue use and replace if damaged
.
•
Inspect connectors and penetrations for any signs of wear or damage prior to use.
•
Always grease wet mate connectors prior to use.
•
There are no user serviceable parts in the OTPS1KW-ASM-ROV-R1 or OTPS1KW-ASM-
TOPSIDE-R2 except for the user access area. Do not attempt to open either the OTPS1KW-
ASM-ROV-R1 or OTPS1KW-ASM-TOPSIDE-R2.
Legend
Safety
Warning
The
OTPS1KW-ASM-ROV-R1
system is supplied with 400V
DC
. Improper use may
result in electrical shock or electrocution. Only trained and experienced
personnel should operate the equipment.
Warning
The OTPS1KW-ASM-TOPSIDE-R2 system is supplied with 100-240V
AC
and
supplies 400V
DC
. Improper use may result in electrical shock or electrocution.
Only trained and experienced personnel should operate the equipment.
Warning
Troubleshooting described in this manual is to be done only by qualified
service personnel. To avoid electrical shock or equipment damage, do not
troubleshoot or service any components unless you are qualified to do so.
Caution
NEVER PLUG OR UNPLUG ELECTRONICS WITH POWER ON! Damage or
personal injury may result.
Warning/
Caution
High Voltage
Summary of Contents for OTPS1KW-ASM-ROV-R1
Page 10: ...10 Tether Wiring...
