1. Check that the control knob (N) for the
gas supply system is turned to the
“OFF” position before starting any
2. Attach right front leg (G), right back leg
(H) and 2pcs left legs (F) to the metal stand (I)
using 4pcs M6x10 screws.
3. Attach 2pcs side panels (E) and front
panel (D)to the legs using 12pcs M6x15
screws and 12pcs M6 nuts.
4. Attach steel base to the bottom part of
the table top (B) using 8pcs M6x15 screws.
ASSEMBLY INSTRUCTIONS
N
M6X15 8pcs
using 4pcs M6x15 screws.
Tighten with screwdriver and wrench(FF).
Tighten with screwdriver and wrench(FF).
Do NOT tighten the screws until all parts are
installed, it may cause some to not be able to
be connected.
Tighten all screws completely with
screwdriver or wrench (FF) after all parts
are connectd.
7
