Outsunny 842-186, Assembly & Instruction Manual

6. Buy at least 1.3m gas hose and regulator 
from local market.
Connect hose & regulator to gas pipe (I).
Insert gas pipe with hose & regulator 
assembly (I/J) through top
of housing (E) and Post (K), tighten gas pipe 
(I) to head assembly(C).
Secure head assembly (C) to the post (K) 
using preassembled bolts M5 x 10 (HH), lock 
washer (JJ), and 

Φ

5 washers (EE).

Note: The control knob on head assembly (C) 
should be aligned with door (F).
The pressure regulator and hose assembly to 
be used must conform to local standard codes.

7. Secure gas hose and regulator (J) onto gas 
cylinder (not included).
Place the gas cylinder into the rear of housing 
(H), then close the door (F).
Note: See instruction Gas requirement and 
Connecting to a gas cylinder before buying a 
gas cylinder.

B ase stands assembly
Secure 3pcs base stands to the base using preassembled 6pcs bolts M5 x 12 (KK), 
6pcs Φ5 washers (EE) and 6pcs

 lock washers (JJ) firstly, then strike suitable 

hook bolts or rawlbolts from local market through the stand holes into the 
ground or floor. (See figure 1)