Outsunny 842-191, Assembly & Instruction Manual

LEAK TESTING 

NEVER USE A NAKED FLAME TO CHECK FOR 
LEAKS. 
NEVER LEAK TEST WHILE SMOKING.

The gas connections on this appliance are leak 
tested at the factory prior to shipment. 
This appliance needs to be periodically checked for 
leaks and an immediate check is required if the 
smell of gas is detected.
- 

Make a soap solution using 1 part of liquid dish-
washing soap to 3 parts water. The soap 
solution can be applied with a soap bottle, 
brush, or rag to the leak tested points shown in 
the figure above. 

- 

The valve of the gas cylinder should be in the 

OFF 

position at this point of the leak test. Once 

the soapy solution is applied to the gas 
connections, the valve of the gas cylinder 
needs to be turned to the 

ON 

position. 

- 

Soap bubbles will begin to form in the soapy 
solution if a leak is present.

- 

In case of a leak, turn off the gas supply. 
Tighten any leaking fittings, then turn the gas 
supply on and recheck.

GAS REQUIREMENTS

- 

The appliance must use an EN12864 or EN16129 approved gas regulator and CE 
approved  gas  hose  with  a  length  of  50cm  (BS3212  and  EN1763-1).  Choose  the 
proper regulator according to outlet pressure in the technical table in page 14. 
You  will  need  to  purchase  suitable  gas  hose  and  regulator  from  your  local  gas 
dealer if the appliance does not include gas hose and regulator.

- 

Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented 
or rusty gas tank may be hazardous and should be checked out by a gas supplier.

- 

Never connect this appliance to an unregulated gas source.

- 

When the appliance is not in use, turn the gas cylinder OFF.

- 

Always perform a leak test on gas connections whenever a cylinder is connected. If 
bubbles  form  in  the  leak  test  solution,  do  not  use.  Never  use  a  flame  to  test  for 
leaks. 

CONNECTING TO A GAS CYLINDER

- 

Recommended to use max.15kg or smaller gas cylinder (maximum height 65cm) 
refer to your gas supplier for suitable gas cylinder.

- 

Approved  gas  regulator  is  used  according  to  appliances  categories  and  countries 
listed  in  data  plate.  Approved  flexible  hose  would  be  changed  when  the  national 
conditions require it. 

- 

Assembly  of  the  tubing  must  be  conducted  by  some  qualified  tuber  of  destination 
countries.

- 

Only  change  gas  cylinders  outdoors  or  in  a  well  ventilated  area  away  from  naked 
flames  and  any  other  source  of  ignition  (candle,  cigarettes,  other  flame  producing 
appliance….).

- 

The gas cylinder must always be used in an upright position. 

- 

Close the heater control knob by turning fully clockwise.

- 

Close the gas cylinder tap and then attach the regulator onto the gas cylinder. 

- 

Tighten all connections firmly and with a spanner where appropriate. The cylinder 
should be located on the cylinder base.

- 

Check for leaks at all joints using soapy water. If a leak is found, tighten the 
joint and then re-test.