Architectural Products by Outwater assumes no liability for improper installation.
Page 3
2. Using a good quality level, lightly score a level pencil line on the header board where the bracket screw will be
fastened into.
3. To splice the rail together using the E-Glide splice kit (EG.41) complete the following steps:
•
Slide the spice half-way into one of the rails and tighten down the 2 set screws
(figure 3, image 1)
•
Slide the other rail over the splice and tighten the set screws
(figure 3, image 2)
4. Slide all the brackets onto the rail, see the recommended spacing below
(figure 4)
. Leave the brackets loose on the
rail at this point.
5. Starting at one end, secure each bracket with the supplied screws to the wood header along the line that was
scored as described in step 2 of this section.
6. After all the brackets are screwed to the wood header and the rail is in the intended position, tighten the small set
screw on front of each bracket to the rail
(figure 4)
.
FIGURE 3
FIGURE 4
Summary of Contents for architectural products E-GLIDE EG.300 Series
Page 12: ...REV 08 13 20 ...
