E-023-2-E
③
Click the "Start" button to display a message box (Fig. 126). Click the "OK" button to start "Fix Status
output".
Click the "Cancel" button to return to the window shown in Fig. 125.
④
Click the "OK" button to cause the simulated output state to be outputted. While the simulated output
is being outputted, a message at the bottom of the window will indicate that the system is "creating
simulated output", as shown in Fig. 127.
Click the "Stop" button to halt the simulated output.
⑤
After the "Stop" button is clicked, a message box (Fig. 128) will be displayed. Click the "OK" button.
⑥
Clicking the "OK" button would return the interface to the window shown in Fig. 125, so click the
"Cancel" button to exit "Fix Status output".
3.7.2.6 Status input loop test (Fix Status input)
This displays the state of status input.
①
Click the "Diag/Service (T)" menu, and then select and click "Fix Status input" from the "Loop Test"
drop-down list.
②
A window will appear as shown in Fig. 129, displaying the current state of status input, either "Short" or
"Open". After verifying the state, click the "Cancel" button and exit "Fix Status input".
Fig.126
Fig.127
Fig.128
Fig.129
