E-122-8-E
1
7.5 Parameter Setup Procedure
7.5.1 Procedure to modify a parameter
Given below is the parameter setup procedure:
For complete detail of MODE and RESET switch operations in steps
①
,
②
,
⑥
and
⑦
, see
"Table 7.5 Menu Trees and Switch Operation" on page 19.
7.5.2 Procedure to Enter a Parameter
The procedure to enter a parameter (switch operations sequence in "Parameter Setup Mode") comes in
three ways (numerical setup, decimal point location setup, and analog 4/20mA trim) that follows:
Meanings and functions of individual parameters appear in the Parameter List on pages 20 and 21.
Kind 1 Numerical setup parameters (F, H, Pu, At, A, AF, dAn, Pon)
The blinking digit in the parameter setup mode is the place of interest.
MODE
…
Each time the switch is turned on, the place of interest moves one place to the left.
RESET
…
Each time the switch is turned on, the figure in the blinking place increases by one.
Or exponential sign toggles ("E", "-", etc.).
→
Following the parameter setup, hold the MODE switch turned ON for more than 2 seconds (the new
setting is established and the screen returns to the review mode).
①
In "Measure Mode (normal mode)", turn MODE switch ON for more than
5 seconds to go into"Review Mode".
②
Using MODE and RESET switches, show the parameter you want to modify.
③
Turn MODE switch ON for more than 2 seconds to go into "Parameter Setup Mode".
④ U
sing MODE and RESET switches, set up a new parameter. (See Para. 7.5.2 below for the procedure.)
⑤
Following the parameter entry, turn MODE switch ON for more than 2 seconds to go back to "Review Mode".
⑥
Using MODE and RESET switches, show the title (= one from bdAtA, AL, AnA, PuLSE, CorrEct, or Co).
⑦
Turn MODE switch ON for more than 5 seconds to go back to "Measure Mode".
A diagram to show parameter setup flow
Measure Mode
(normal mode)
Review Mode
Parameter Setup
Mode
③
⑤
②
⑥
①
⑦
④
Example: Parameter "F" (meter factor)
Exponential sign (E:10
+n
, -: 10
-n
)
(The screen left reads F=1.2345
×
10
+2
L.)
Digit of interest (blinking)
L
●
Turning MODE "ON" moves the blinking digit one place to the left ("E").
●
Turning RESET "ON" increases the figure by one ("2"
→
"3").
