Ovarro LD Ltd
User Manual
XiLOG 4G/IOT
Document Number:
Template Number: IXD-956 iss 05
Version: 1.0
Page 26 of 42
5.12
Configure Channels - Current Screen
The
Current
screen enables configuration of the analogue
connector current values and corresponding pressure sensor
readings. Click the tick (
) to commit configuration
changes to the logger.
Caution: Exceeding the 20mA range by more than 50%
will cause damage to the logger.
Note:
The external sensor can be powered from the
logger, which applies power for short intervals.
20mA is a high drain on the internal battery, so
external power should be considered.
Name
– Defines name of the channel that will be
displayed in Primeweb.
Units
– Specifies the pressure units to be used (BAR or
PSI).
Log Every
– Defines the required logging interval for
pressure measurement data (1sec to 1 hour).
Sensor Configuration
Units
– Specifies the units for pressure (BAR or PSI).
Max (BAR)
– Specifies the maximum pressure measured
by the sensor.
Min (BAR)
– Specifies the minimum pressure measured
by the sensor.
mA at Max
– Specifies the current of the sensor in mA at
maximum pressure.
mA at Min
– Specifies the current of the sensor in mA at
minimum pressure.
XiLOG GO - Current Screen
