Ovation HONOR 250C ZOOM, User Manual

5

V1.0

www.ovationlight.com

Installation

Read ‘Safety information’ before installing the fixture.

The fixture is designed for indoor use only and must be used in a dry location with adequate ventilation. 
Ensure that none of the fixture’s ventilation slots are blocked.

Fasten the fixture to a secure structure or surface. Do not stand it on a surface or leave it where it can 
be moved or fall over. If you install the fixture in a location where it may cause injury or damage if it falls, 
secure it as directed in this user manual using a securely anchored safety cable that will hold the fixture if 

the primary fastening method fails.

Fastening the fixture to a 

flat

 surface

The fixture can be fastened to a hard, fixed, 

flat

 surface that is oriented at any angle. Ensure that the sur-

face and all fasteners used can support at least 10 times the weight of all fixtures and equipment to be 

installed on it.

Fasten the fixture securely. Do not stand it on a surface or leave it where it can be moved or fall over. If 
you install the fixture in a location where it may cause injury or damage if it falls, secure it as directed be

-

low with a securely anchored safety cable that will hold the fixture if the primary fastening method fails.

Mounting the fixture on a truss

The fixture can be clamped to a truss or similar rigging structure in any orientation. When installing the 
fixture hanging vertically down, you can use an open-type clamp such as a G-clamp. When installing in 

any other orientation, you must use a half-coupler clamp that completely encircles the truss chord.

To clamp the fixture to a truss:

1. 

Check that the rigging structure can support at least 10 times the weight of all fixtures and equipment 

to be installed on it.

2.  Block access under the work area.
3.  Fold the legs of the mounting bracket together and bolt a rigging clamp securely to the mounting 

bracket. The bolt used must be M10, grade 8.8 steel minimum. It must pass through both mounting 

bracket legs and be fastened with a self-locking nut.

4. 

Working from a stable platform, hang the fixture with its clamp on the truss and fasten the clamp se

-

curely.

5. 

Secure the fixture with a safety cable as directed below.