Over Armour Offroad
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Textron Stampede 4
Full Cab fits Aero-Vent Poly Windshield
TX-STAMP-4-FC04
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
1.
Be sure to read these instructions thoroughly before opening and installing the Textron
Stampede 4 Full Cab fits Poly Windshield. The installation is best done when the
temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if
conditions prevent installing in warmer weather it helps to store the adhesive Velcro at
room temperature prior to installation.
2.
Carefully open the carton and remove the enclosure on a large flat surface that is clean
and free of dirt.
3.
Check over the parts included in the carton with the parts list shown below:
Adhesive Velcro Hook Strips:
Soft Doors
“ “ “ “
28 each------------3"
“ “ “ “
2 each------------32”
Polycarbonate Door Panel
2 each
Panel Screws
8 each
Snap Screw Studs
21 each ( 1 extra )
---------------------------------------------------------------------------
Adhesive Velcro Hook Strips:
Rear Window
“ “ “ “
2 each------------16”
Snap Screw Studs
3 each
---------------------------------------------------------------------------
Top Cap
36” Webbing Straps w/ Loop
4 each
The cab for you Stampede 4 is made up of 4 different components that work together to enclose
your vehicle. Install the cab in the following order.
1) Soft Doors
2) Rear Window
4) Top Cap
