Figure 13
Figure 15
Figure 14
6. After the main ramp assembly is resting
on pickup bed, use the removable corded
control to move the motorcycle forward
until it stops short of the front of the pickup
bed.
7. Use tie-downs to strap down the rest of the
bike. Installation and loading is complete.
Use additional tie downs (not included)—
securing the bike to the pickup bed in a
minimum of four additional places.
8. Periodically check straps during travel to
make sure straps are secure.
TROUBLESHOOTING
• If the second of the two ramp extensions
does not install properly during assembly,
verify that they are in the correct positions.
See page 3 for an illustration and pages 4
and 5 for the installation.
• In the unlikely event that the gear for the
cradle on the main ramp should slip, simply
torque the center adjustment bolt to 20 ft.
lbs. to prevent future occurrences. See
Figure A below for the location.
• If necessary, stop the bike short of the
ramp pin when loading. Remove the pin
and load the bike. Do this if one tire covers
the ramp pin needing to be removed when
taking aprt the ramp.
Page 7 of 7
09/06
Figure A
