6
INSTALLING DIGITAL DISPLAY HOUSING
1. Determine mounting location and method.
2. Remove rear panel. Orient enclosure with RJ45 connector at the top.
3. Remove knock out plug in housing for best connection for the installation.
4. Install RJ45 watertight bulkhead connector (included) into housing.
5. Install the 1ft long Cat 5 cable into rear of display panel and RJ45 connector.
6. Install rear panel cover.
NOTE:
If mounting outside building or in damp conditions it is highly recommended to apply a bead of silicone
caulking around rear panel and rear panel screws.
7. Install mounting brackets to main housing to best suit the installation.
8. Mount brackets to suitable structure.
1-ft long CAT5 cable
Mounting and bulkhead
connector installation shown here
is for example only. Installations
may vary.
IMPORTANT NOTE:
If display is to be mounted outdoors, use of RJ45 watertight connector must be
used to prevent water intrusion into display box. See instructions next page.
!
TOP
Water Tight
RJ45 Bulkhead
Connector
Washer and Nut
