Overhead door OverDrive, User Manual

24

3. Operate remote control.

•  Point remote control at door.
•  Press button on remote control. 

– Door moves.

•  Press button again.

– Door stops.

•  Press button again.

– Door reverses.

NOTE: Door automatically stops at end of open
or close cycle.

NOTE: A maximum of 7 remote control, wireless
keypad and other access device codes can be
stored into the receiver at one time. If a remote
control becomes lost, or if you want to delete a
remote control, wireless keypad or other access
device, proceed to next step, ERASING ALL
RECEIVER MEMORY.

4. Erasing all receiver memory.

•  Press and hold learn code button on 

power head. 
– 10 seconds or until light goes out

• Memory is erased.
•  Program door operator again.

FCC and IC CERTIFIED

This device complies with FCC Part 15 and RSS 210

of Industry Canada. This equipment has been tested and
found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or 
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures: 

•  Re-orient or relocate the receiver antenna.
•  Increase the separation between the operator 

and receiver.

•  Connect the operator into an outlet on a circuit 

different from that to which the appliance is connected.

•  Consult the dealer.

1. Remove covers (Fig. 6-4). 

• Slide keypad cover up and remove.

• Slide battery cover down and remove.
• Remove battery.

2. Mount keypad (Fig. 6-4).

•  Find flat vertical surface.

– With room above to slide cover up.
– In sight of door and away from moving parts.
– At least 5 feet from floor, so small children can

not reach it.

– Out of direct weather.  

• Mark holes.
•  Drill 1/16” holes. 
•  Fasten with 2 pan head screws [41]. 
•  Slide keypad cover on keypad. 

3. Replace battery (Fig. 6-4).

•  Slide battery cover down and remove (If required).
• Remove battery.
•  Install an                 1222, 9 volt battery.
•  Slide battery cover onto keypad.

Fig. 6-4 Install wireless keypad

KEYPAD
COVER

BATTERY COVER

MOUNTING
SCREWS

41

WIRELESS KEYPAD INSTALLATION

¤

NOT INCLUDED WITH ALL MODELS