FOR ASSISTANCE CALL 1-800-275-6187
6.2
Setting Constant Contact
IDLE DOWN LIMIT
OPEN MODE C-STP
CLOSE MODE MOM
Figure 2
Figure 3
Figure 4
Door closed -
operator
standing by
CLOSE MODE C-STP
Figure 5
RMX™ Operators are shipped from the factory with both open and close
operating modes set to constant contact – stop (C – STP) If your unit is set
to Momentary Contact (MOM) Open and/or CLOSE, reset the
operating modes by taking the following steps:
1) Press CAL/RUN to enter calibration mode.
Fig. 2
.
2) Press SET/CLEAR until display reads “OPEN MODE
>
C-STP.”
Fig. 3
.
3) Press SCROLL (DN) until display reads “CLOSE MODE.”
Fig. 4
.
4) Press SET/CLEAR until display reads “CLOSE MODE
>
C-STP.”
Fig. 5
.
5) Press CAL/RUN to return to run mode.
WARNING:
If an external reversing device is not used, then the operator
must be used with only a Constant Contact Control. Verify close
mode is set to “C-STP” and NOT “C-REV” or “MOM” before
continuing.
07/30/09
