26
Chapter 2 - Installation
Figure 2-11
Separating a Rack Slide
2.
Refer to Figure 2-11. Separate each set of slides as follows:
a)
Pull the outer slide toward the rear, along with the intermediate slide until the
inner slide lock engages the intermediate slide.
b)
Continue to pull the outer slide towards the rear until the outer slide lock
engages the intermediate slide. Press down on the inner slide lock to permit the
intermediate slide to continue to move toward the rear. Continue to move the
outer and intermediate slides toward the rear until they are separated from the
inner slide.
3. Locate the screw holes in the front and rear rails of the cabinet or equipment rack
where the module is to be installed.
4. Assemble a mounting bracket to each outer slide, using two 10-32 screws with
washers and a nut plate for each. Select slots in the mounting brackets so the length
of the assembly equals the distance between the front and rear rails of the rack.
Finger tighten only.
5. Fasten each outer slide behind the front rail of the rack using two 10-32 stainless
steel low-profile screws and one nut plate.
6. Fasten each of the mounting brackets to the front of the rear rail of the rack using
two 10-32 screws and one nut plate.
7. Tighten the screws installed in step 4.
8. Pull the intermediate slides toward the front (out of the rack) so that they lock in the
extended position.
Summary of Contents for DLT LibraryXpress Series
