Chapter 3 - Operation
67
4. Press
the
Enter
button to select the Security Menu, shown in Figure 3-34.
Figure 3-34
Security Menu
5. Press
the button once to move the next to ‘Unlock All Media’, then press the
Enter
button. The display will appear as follows.
Figure 3-35
Unlock All Media Screen
6. When the words ‘In Progress’ disappear, press the
Escape
button repeatedly until
the Default Screen appears.
7. Press
the
Unlock/Open
Button on the front panel of the Module. If the module does
not unlock, be sure that the key lock on the Module’s front panel is unlocked.
8. When the ‘Door Open’ message flashes, grasp the handle, and pull the magazine
from the module.
Emergency Magazine Removal
If a fault occurs that prevents removal of the magazine, turn the power off for five seconds.
Power up while continuously pressing the
π
button. Continue to hold the button until all of the
indicators on the control panel light, then go out. Release the button. The magazine may now
be removed.
If you are unsuccessful in removing the magazine using this procedure, refer to the section
titled ‘Cartridge Magazine Removal’ in Chapter 6 - Parts Removal and Replacement for
alternate procedures.
Inserting Cartridges Into the Magazine
A full magazine is shown in Figure 3-36. Insert cartridges so that the label end with the write
protect switch is outward, with the write protect switch toward the bottom of the magazine.
The lowest numbered cartridge slot in the magazine is closest to the handle
Unlock All Panels
Unlock All Media
Lock All Panels
Lock All Media
Unlock All Media
In Progress
Summary of Contents for DLT LibraryXpress Series
