4-4
u
Maintenance
C
LEANING
C
ARTRIDGE
When you press the
Enter
button, the
In Progress
screen appears.
Figure 4-5. Cleaning In Progress Screen
When the cleaning operation is completed, the Default Screen reappears.
Removing the Cleaning Cartridge
1) Examine the Default Screen on the Control Panel to assure that the cleaning cartridge has
been unloaded from the drive. If not, then unload it using the Load/Unload Menu, as described
in
2) Remove the magazine from the PowerLoader using the procedure described in
,
“Inserting and Removing Cartridges”
3) Remove the cleaning cartridge from the magazine.
4) Insert any desired data cartridge into the slot vacated by the cleaning cartridge.
5) Insert the magazine into the PowerLoader.
6) Close the magazine door.
Clean:
Clean:
Clean:
Clean:
SDLT1
SDLT1
SDLT1
SDLT1
Use:
Use:
Use:
Use:
Slot1
Slot1
Slot1
Slot1
Cleaning in Progress
Cleaning in Progress
Cleaning in Progress
Cleaning in Progress
Summary of Contents for LXLS10
