Troubleshooting
t
5-3
F
AULT
S
YMPTOM
C
ODES
(FSC)
Fault Symptom Codes (FSC)
If a fault persists, look up the FSC in the following table and call your Technical Support
Representative
Table 5-2. Fault Symptom Codes
FSC
Message
Description
ERP
0101
Unused Interrupt
Enter to Reboot or
Power Down to Clear
Firmware error - HARD fault - the code tried
to execute an un-initialized (unused)
interrupt vector.
C, D, G
0102
Enqueue'g a Null Ptr
Enter to Reboot or
Power Down to Clear
HARD fault - a request was made to add a
NULL pointer to a message queue.
C, D, G
0103
Invalid Cmd Rec'd
Enter to Reboot or
Power Down to Clear
HARD fault - This library is configured as a
slave and has received an illegal command
from the remote master. This cannot happen
with LTO loaders.
C, D, G
0201
Trc. Comm Open
Error
Enter to Reboot or
Power Down to Clear
HARD fault - Unable to open the trace serial
port. The loopback test of the baud rate
divisor registers or one of the "expected 0" bit
tests failed.
C, D, G
0301
Novram Init. Error
Enter to Reboot or
Power Down to Clear
HARD fault - The firmware was unable to
write data to the novram during
initialization.
C, D, G
0302
Novram Chksum
Error
Press Enter to Init
Novram to Def. Cfg.
SOFT fault - The novram checksum did not
match the data. The novram needs to be re-
initialized.
F
0303
Novram Program
Error
Enter to Reboot or
Power Down to Clear
HARD fault - The firmware was unable to
write data to the novram during an edit
operation.
C, D, G
0304
Novram Downld.
Error
Press Enter to Clear
SOFT fault - The system was unable to
import data from the serial port to update
the novram. The novram contents are
unchanged.
F
0305
Novram Data Error
Press Enter to Clear
SOFT fault - The novram checksum did not
match the data during a validation check.
F
0306
Novram Update
Error
Enter to Reboot or
Power Down to Clear
HARD fault - The novram did not update
properly. The checksum and data no longer
match.
C, D, G
Summary of Contents for LXLS10
