Overland Storage NEO 8000, Unpacking Instructions

Part Number 104373-102 05/2008

©2005 - 2008 Overland Storage, Inc.

Page 4 of 4

e. Lower

 the door so that the top hinge pin is above 

the library hinge block hole and 

seat 

it.

5.

Check the door to make sure it closes smoothly, yet is 
held firmly.

6.

If the door does not close as described in 

Step 5

, adjust 

it for alignment and operation:

a.

Using the flat-blade offset screwdriver, unscrew the 

door checks

 in both left library hinge blocks until 

the door closes freely (

Figure 7 on page 3

).

b.

Close the door and check that the 

top edge

 of the 

door meets the front panel façade evenly.

•

If the door is 

low

, add washers to raise the door.

•

If the door is 

high

, remove the top washer.

CAUTION:  

The weight of the door should be 

carried by at least one hinge with a nylon washer 
(i.e., there must be at least one washer).

c.

When the door height is correct, screw in the 

door 

checks 

until the door closes smoothly, yet is held 

firmly.

7.

Repeat 

Steps 4–5

 for the 

right

 door; if needed, 

repeat

Step 6

.

Move the library into its final position and level it:

CAUTION:  

Do not pull on the media drawer handles 

when moving the library.

1.

Position

 the library at its operating location.

2.

Run down 

all four leveling legs

 by hand until they 

contact the floor.

3.

Using the 10” adjustable wrench, 

turn

 each leg, one 

after the other in equal increments, until you have 
turned them at least one full turn.

NOTE: Be sure the library has been raised high enough so 
none of the casters touch the floor.

4.

Place the level, front to rear, on the 

top side edge

 of 

the library (see 

Figure 8

).

5.

Note the position of the bubble. 

Raise

 both of the front 

legs or both of the rear legs the 

same amount

 to 

achieve a level front-to-rear reading.

6.

Place the level across the 

top front edge

 of the library.

7.

Note the position of the bubble. 

Raise

 both of the left 

feet or both of the right feet the 

same amount

 to 

achieve a level side-to-side reading. 

8.

Recheck

 the level from front-to-rear and from 

side-to-side. Adjust as needed until the library is level.

Figure 8.  Positioning the Level

You are now ready to connect the library to your network. Refer to the 

Overland NEO 8000 Library User Guide

 for 

information required to complete this installation.

Leveling the Library

N

EO

-8

11

2

What’s Next?

Additional Help

You can get additional technical support on the Internet at 

http://support.overlandstorage.com

, or call 

1-877-654-3429 (toll-free U.S. & Canada), +44 (0) 118-9898050 (Europe), or +1 (858) 571-5555 Option 5 (International).