10400839-001
©2017 Overland Storage, Inc.
Page 3 of 4
NEO Add-on/Spare 10GbE Card Instructions
Install a New 10GbE Card
1.
At the rear right, remove and retain the
slot locking
plate screw
from the optional PCIe cards area.
2.
Slide the
card locking plate
toward the outside until the
pins are as far over as they can go.
3.
Insert the
new 10GbE card
into the empty slot and seat
it properly.
Verify the bracket is correctly positioned.
4.
Slide the
card locking plate
all the way toward the
bracket top to secure both cards.
5.
Using the
retained screw
, secure the locking plate.
Complete the Replacement
Reinstall Top Panel
1.
Align the top panel over the appliance with no more than
one-half inch
(1.25cm) extending out over the rear and
gently press it down onto the Agility 48.
2.
Slide the panel
forward
into position.
3.
Press and release the
two top panel buttons
to ensure
the panel is securely seated.
Reinstall Appliance in Rack
1.
Fully extend the
outer rails
from the rack to the front.
2.
Using the mechanical lifter, position the
appliance
in
front of the rack, aligning the
inner rails
with the rack
outer rails
.
3.
Slide the chassis into the rail racks, keeping the pressure
even on both sides, until the
locking tabs
click into place.
NOTE: You may need to depress the locking tabs when
reinstalling the appliance to ensure they are securely seated.
4.
Reinstall the retained
two screws
in the front appliance
flanges to secure the appliance to the rack.
Attach the Bezel
1.
Holding the bezel level horizontally and at a 45º angle to
the front, insert the
left bezel tabs
into the
left flange.
2.
Pressing in the release latch on the right, swing the
bezel
into place on the right, and let go the latch to secure it.
3.
If needed,
lock
the bezel using the supplied key.
Depress
Buttons
Extend
Outer Rails
Locking Tab
