10400844-001 12/2017
©2017 Overland Storage
Page 2 of 4
SnapServer XSR120 Add-on/Spare PCIe Card Instructions
Remove the Front Bezel
1.
Carefully take hold of the
front bezel
and pull it straight
out from the appliance until it releases.
2.
Set the bezel
aside on a
secure surface
.
Remove the Drives
IMPORTANT: Overland recommends that you remove all the
drive carriers to reduce the unit’s weight prior to rack removal.
Blank (empty) carriers can remain in the bays.
1.
Press the release
button
on the right side of the carrier.
2.
Using the built-in
handle
, pull the carrier out.
3.
S
et the
drive carrier
on a secure surface.
4.
all
the remaining drive carriers.
NOTE: Do not remove the drives from their carriers as doing so
voids the drive warranty.
Remove the Chassis from the Rack
WARNING:
It is recommended that a mechanical lifter (or at
least two people) be used during rack installation or removal to
prevent injury.
WARNUNG:
Um Verletzungen zu vermeiden, empfehlen wir zur
Rack-Installation oder -Deinstallation die Nutzung einer
mechanischen Hebehilfe (oder mindestens zwei Personen).
AVERTISSEMENT:
Pour éviter toute blessure il est
recommande qu'un monte-charge (ou deux personnes au
moins) soit utilisé lors de l'installation ou de l'enlèvement du
support.
1.
Release the
two captive screws
on the lower part of the
left and right front flanges.
2.
Slide the
chassis
out until it stops.
3.
With a lifter positioned in front of the chassis, release the
rail locks
and slide the chassis onto the lifter.
4.
Move the chassis onto a
secure surface
.
Install/Replace the PCIe Card
Remove the Rear Top Panel
1.
Remove and retain the
four screws
on the sides holding
the rear top panel.
2.
Using the panel depressions, slide the panel rearward
about
one-half inch
(1.25cm).
3.
Lift the
rear top panel
off and set it aside.
1
2
3
4
5
6
7
8
9
10
11
12
Press
Chassis
Secure Surface
Screws
Screws
