1. Before the installation,
please turn off the
motorcycle.
2. Use cable ties to attach the
voltage converter to your
motorcycle.
3. Insert a micro SD card and
glue the holder of the
controller in an accessible
place.
4. Install the controller in the
attached holder.
5. Glue the camera holder in
a safe desirable place.
6. Use the mini HDMI cable to
connect the controller and
the camera.
7. Use the mini USB power
cable to connect the
converter and the controller.
8. Make sure the cables have
been properly connected to
the controller, and then
secure them with the supplied
lock.
9. Turn on the motorcycle.
The converter will turn on as
well and the camera will start
recording.
LED status
Status
Recording
LED
Charging LED
Status LEDs
Signal
LED colour
Red
Red
Blue
Red (1080p)
Blue (720p)
Beep
Turning on
On
Off
Flashing
Flashing
Off
3 beeps
Turning off
On
Off
Flashing
On
Off
6 beeps
Recording
Flashing
On
Off
It brightens
and darkens
It brightens
and darkens
1 beep
Standby
On
On
Off
On
Off
2 long
beeps
Empty SD
slot
Flashing
fast
On
Off
Flashing
Flashing
2
seconds
Memory
card is full
Flashing
fast
On
Off
Flashing fast
Flashing
4 beeps
Battery
charging
On
On
Off
On
Off
Off
Low battery
On
On
On
On
Off
Off
