Engine / ignition start mode
Turning
Motocam 3.0
on
After installation of the converter, the camera starts
automatically the moment you turn on the ignition.
Turning
Motocam 3.0
off
When you turn the ignition off, the camera saves data
on the memory card and turns off automatically.
Turning the camera on / off using the power button
Turning
Motocam 3.0
on
Short press the power button to turn on the camera.
The camera emits 3 beep sounds. The charging LED
starts flashing blue and the status LEDs start to glow
red. A single beep indicates the start of the recording.
The recording indicator flashes and the status LEDs
slowly brighten and darken alternately.
Turning
Motocam 3.0
off
Press and hold the power button for about 3 seconds
to turn the camera off. The charging LED flashes blue
and the camera emits six beeps. Then, all the LEDs
turn off.
Empty SD slot
If there is no micro SD memory card installed in the camera, the status
LEDs flash red and blue, , and the camera turns off after 30 seconds.
Memory card is full
If the loop recording is off, when the memory card is full, the camera
turns off automatically after 1 minute.
If the loop recording is on, when the memory card is full, the camera
overwrites the oldest files with the new ones.
Note:
Please install a micro SD card into the camera before you start
using it.
Micro SD card capacity / video file time
Mode
Video
FAT32 file system 4GB
8GB
16GB
32GB
64GB (Fat32)
1080P @30FPS
30 min 60 min 120 min 235 min 470 min
720P @60FPS
35 min 70 min 140 min 270 min 530 min
