TRANSMITTER AND RECEIVER SYNCHRONIZATION
Step 1
Open the battery cover. Place the battery in the
drone's battery compartment and connect the battery
Step 2
Turn the controller on.
Step 3
Turn on your X-Bee Drone 1.5 using the switch
located on the bottom of the drone. The LEDs start to
blink.
Step 4
Place the drone on a flat and even surface.
Step 5
Move the throttle stick forward, and then backward.
The controller emits the sound indicating that the
connection with the drone has been established. The
LEDs start to glow steadily.
Step 6
Engines calibration Place the drone on a flat and even
surface. Move the left stick to the lower left corner, and
the right stick to the lower right corner, as shown in the
picture. Hold these positions for 10 seconds. The
drone's LEDs will blink several times, and then they will
start to glow steadily. Now, you can release the sticks -
the drone is ready to fly.
REMEMBER TO CALIBRATE
THE DEVICE BEFORE EACH START. OTHERWISE
THE UNIT MAY NOT WORK PROPERLY.
