EN
PREPARATION FOR FLIGHT
1. The drone is intended for both outdoor and indoor use. Before you start us-
ing the product, make sure there area you have chosen is free from obstacles,
people and animals. If you are outdoors, avoid rain, snow and wind.
2. Make sure the battery has been fully charged and inserted in the drone.
Press the switch at the bottom of the drone and place it on a flat surface. The
drone lights will start flashing.
3. Activate the remote control, move the choke valve upwards to the limit,
then downwards to the limit. The lights should glow constantly, if this is the
case – the remote control has connected to the drone successfully.
4. Drone calibration. Move both controllers towards the right bottom corner.
The drone lights will flash for a while and then glow constantly. The drone has
been calibrated.
5. Start the motors by moving the left controller towards the left bottom cor-
ner, and right towards the right lower corner.
DRONE CONTROL
1. To raise or drop the drone, move the left
controller upwards or downwards.
Summary of Contents for X-bee drone 3.3 Wi-Fi
Page 1: ...X bee drone 3 3 Wi Fi User Manual Instrukcja obsługi RO PL EN HU CR DE ...
Page 2: ...PL www overmax eu ...
Page 63: ......
Page 64: ...PL www overmax eu ...