EN
•
Use batteries of the same type or equivalents only.
•
When inserting batteries, pay attention to polarization.
•
Storage batteries must be removed from the drone before they are charged.
•
Storage batteries can be charged only if supervised by an adult.
•
Worn-out storage batteries must be removed from the drone.
•
Power terminals must not be short-circuit.
•
USB cable must be regularly checked for potential hazard, such as damage to the
cable or wire, plug, casing or other parts. The product must not be used until potential
damage is properly eliminated.
•
After using the drone, charge it for an hour to maintain its battery life.
•
If you do not use the device for a long time, it is advisable to discharge and charge the
storage battery once a month to avoid damage.
Low battery of the controller
When the controller emits sounds and the battery status (
) flashes on LCD screen, it means
that the battery is about to go flat. Replace the battery in the controller.
How to put batteries into the controller
Open the battery cover, fix two AA batteries in the compartment in accordance with terminal
marks and then close the cover.
Signal strength indicator
The icon (K in fig. 8) show the signal strength received by the controller from the drone.
The more the bars, the stronger the signal. If the icon shows maximum two signal bars or
there is no bar, and the controller emits a sound, it may mean two things:
1.
The distance between the drone and controller is too big. Reduce the distance.
2.
The remote control battery has been removed after pairing the drone with controller.
To make the signal as strong as possible, make sure the drone flies above the controller and
there are no obstacles between the controller and drone (fig. 13).
How to assemble and disassemble drone propellers
Propellers are marked as “A” and “B” - when assembling, please pay special attention to this
marking.
A – Assembly of the propeller rotating in a clockwise manner
Assemble the propeller marked as “A” on the relevant motor. Tighten up two screws with the
use of screwdriver in a clockwise manner (fig. 6a).
Summary of Contents for X-bee
