Manual plastic bending machine
O-501 / O-801 / O-1301 / O-2001 / O-1302 / O-2002 / O-1304 / O-2004
WARNING: do not place on machine unattended objects
WARNING: No contact with flammable products
WARNING make sure you have adequate ventilation when working with gasifying materials.
Use heat resistant gloves Use safety goggles
CAUTION: Do not operate without proper electrical ground
DANGER: To prevent the risk of severe or fatal electrical shock, special precautions must be taken.
Equipment should be plugged into an approved Ground Fault Circuit Interrupt (GFCI) receptacle.
Intended for indoor use only
Do not alter the construction or design. Do not remove safety labels or devices.
For keeping warranty always use machine according to usage and always use original parts for service.
Do not exceed equipment's maximum rated flow capacity and/or operating pressure.
Do not use equipment for other than its intended purpose, as described in the equipment manual.
Equipment should be protected from the elements and from temperatures below freezing.
On equipment with blowers keep inlet and outlet vents, clean and clear of objects.
CAUTION: Machine can be used only in dry places
Do not operate equipment if the power cord and/or plug are damaged, or if any other damage to the unit is visible or suspected.
Machine must not be disposed of in the trash.
Please use instructions for machine´s installation.
If a defect is detected, do not use the machine and contact the producer.
Make sure you have adequate ventilation when working with gasifying materials.
All occupants and personnel should be alerted to the potential hazards indicated by the product safety labelling on this unit.
The following conventions are used to indicate and classify precautions and on product safety labelling. Failure to observe
precautions could result in injury to people or damage to property.
WARNING: Never touch heating lines risk of burns.
WARNING: Always disconnect power, to the equipment and unplug, before performing any service or maintenance,
is detected, do not use the machine and contact the producer.
