3. HOW TO REPLACE THE BELT (cont.)
Page 7
STEP 4
STEP 7
STEP 8
STEP 5
STEP 6
If the belt is stretched or cut, pull it
out from the motor pulley, as
illustrated above.
1-Put the brush roll cover back over
the brush roll.
2-Replace the 2 screws and make
sure the cover is well attached.
1-The wand port must be in the
upright position and locked in place.
2-Put the cover back on top of the
electric carpet beater (powerhead).
3-Turn the carpet beater (power-
head) over.
4-Replace the screws, as illustrated in
step 1.
1-Lift the end of the brush roll.
2-Remove the old belt and replace it
with the new one. Make sure the
lettering is facing you and that it is
visible.
3-Stretch the belt and attach it to the
motor pulley.
Verify/remove
the belt
Replace the
brush roll
Replace the carpet beater
(powerhead) cover
Remove/replace
the belt
1-Hold the opposite end of the brush
roll in place.
2-Push the belt end forward and
down while rotating the endplate
until it slides into place.
3-Turn the brush roll to make sure it
rotates freely.
Replace the
brush roll
STEP 9
Replace the 7 screws as illustrated
above.
Screw the powerhead
cover in place
