operate.
Picture A Picture B
5.
Support 10 points finger touch (10 people can write together)
6.
Support Larger active size: support 40-100” for the room with sunlight (if the room without
sunlight, it can support the active size of 40-120”.
7.
Portable, high integration and easy to install: Total weight is only around 500g. The
installation is very easy, just need to put the emitter part on the upper of projection Screen,
and the sensor mounted to projector or ceiling, No skill needed.
8.
Sensor with the flash chips: don’t need to calibration if you change the computer with the
same resolution ratio. It save time, and make the use easier.
9.
The product is smaller. Emitter part size is 35cm x 17cm x 2.4cm; it can put on the board
directly.
10.
Wireless connection: Wireless connection between emitter and sensor, and sensor wireless
control the emitter’s on and off. This make product more durable.
11.
Sensor’s filter with Auto push-pull device: When do auto calibration, the filter will be open;
after calibration, the filter will be closed automatically. Such action makes the product more
stable to defense the interference light, and the auto calibration success easier.
12.
Turn common board or wall to touch board. It can turn any flat surface (whiteboard, wall
and so on) into finger touchable.
13.
Any non-transparent object can be used as pen, like a rolled paper. In any active area, any
non-transparent object can work instead of the pen and the mouse.
