Mini Digital Amplifier, with MIC Mixer and EQ
13
IR receiver/sensor Model AMP-IRMA40S
The IR receiver/sensor AMP-IRMA40S is used to receive the IR code from the remote
controller AMP-IRMA40RC. It connects to the AMP-MA40 by 3pins capture screw
connector, and receives the IR code by the IR sensor. The IR sensor can be sticked on
the wall or ceiling. The IR receiver is about 4’ 11” (1.5 meters) in length.
Please check the pictures below:
Connection:
Back side of the IR
sensor
IR sensor.
The yellow tape can
make it stick on the wall
or ceiling.
Capture screw
connector
Capture screw connector
It is connected to the “REMOTE”
port of the AMP-MA40.
Connected to the
“REMOTE” port.
Model
AMP-IRMA40RC
Wireless IR
Model
AMP-MA40
Digital Mini Amplifier
Model
AMP-IRMA40S
The cable is about 4’ 11”
(1.5 meters) long
