15
GB
You may reactivate reception by pressing and holding the
DOWN-/ button
9
for three seconds until an radio tower
symbol in the clock field
24
becomes animated.
You also have the option to set the time manually. For more details
please refer to section
Basic settings
.
Mounting the temperature station and / or the outdoor
sensor on a wall:
Note:
You will require an electric drill and a cross head screwdriver
for this step.
CAUTION! DANGER TO LIFE, RISK OF INJURY AND
MATERIAL DAMAGE!
Read the operating and safety instructions
for your drill carefully.
DANGER TO LIFE!
Take care that you do not hit electricity, gas
or water lines when you drill into the wall. If necessary, check
with a pipe and cable detector before drilling.
Note:
Before mounting the temperature station, please fall back the
stand
6
from back side.
Mark the position of the hole (Ø approx. 8 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
33
into the drilled hole.
Using a cross head screwdriver, screw the screw
32
into the dowel.
Hang the temperature station or outdoor sensor by placing the
hanging slot
4
,
19
to the according screw.
Note:
Ensure that the outdoor sensor shouldn’t be immersed into water
and not contact with direct sunlight. Electronic devices may adversely
affect the wireless signal reception.
