Once all the arms are put in place, secure them in place by
tightening the screws.
Mount the base to your table top.
If the default clamp size does not fit your table top size, try
adjusting the clamp size by repositioning the bottom plate.
STEP 1:
Installing the base
STEP 2:
Installing the arms
STEP 3:
Installing the VESA plate
STEP 4:
Mounting the monitors
Install the VESA plate to the back of your monitor. Make sure
you install the clip facing upwards. Our VESA plate is
compatible with both 75x75mm and 100x100mm mounts.
You can easily slide down the VESA plate into the monitor
arm bracket.
To remove, press the clip at the top while pulling the
monitor up.
Cable Management
Use the built-in cable management to tidy up your cables.
Removing the cover plate may need some force, be careful
not to damage it while doing so.
Adjustments
The default adjustments work for most use cases. You may
look into these finer adjustments to make them suit your
needs.
Adjusts the verticle tilt tightness
Adjusts the horizontal tilt tightness
If your monitor seems too heavy or too light to easily adjust
its height, tightening the weight screw may help.
Important:
Unlike other screws, turning this screw anti-
clockwise will make it tighter, requiring more weight to
move the monitor up or down.
