6.Communication with PC
38
Figure 6-1: Set the network parameters of the computer
(3)
Set the network parameters of the ultrawave software.
Run the software on the
computer, choose the "Ports-settings" of the "Communications" menu item. Set
"Connect using" to LAN. About the IP, the first three bytes is same as the IP in the
step (2), the last byte should be different. Here, we set it to 192.168.1.99. The range
of the port value is 0 - 4000, but the port which under 2000 is always be used, so it is
suggested to set it to the value above 2000. Here, we set it to 3000.
Figure 6-2: Set the network parameters of the ultrawave software
(4)
Set the network parameters of the Waveform Generator
. In the Waveform
Generator, press
Utility
and choose
I/O Setup
, press
F2
to choose LAN, enter
the submenu. Set the
IP
Addr
and the
Port
to the same value as the "Ports-settings"
in the software in step (3). About the setting method, please refer to "
on P33. After restarting the Waveform Generator, if you can get data normally in the
ultrawave
software, the connection is successful.
