5.Front Panel Operation
Figure 5-2: Set the frequency using number keys
To Set the Amplitude
Press
F2
, confirm whether the "
Ampl
" menu item is highlighted; if not, press
F2
to
switch into "
Ampl
". In the Parameter bar 2, a cursor appears under the value of amplitude.
Use the
knob
or the number keys to set the desired value.
To Set the Offset
Press
F3
, confirm whether the "
Offset
" menu item is highlighted; if not, press
F3
to
switch into "
Offset
". In the Parameter bar 2, a cursor appears under the value of offset.
Use the
knob
or the number keys to set the desired value.
To Set the High Level
Press
F2
, confirm whether the "
Hi_Level
" menu item is highlighted; if not, press
F2
to switch into "
Hi_Level
". In the Parameter bar 2, a cursor appears under the value of
amplitude. Use the
knob
or the number keys to set the desired value.
To Set the Low Level
Press
F3
, confirm whether the "
Lo_Level
" menu item is highlighted; if not, press
F3
to switch into "
Lo_Level
". In the Parameter bar 2, a cursor appears under the value of
offset. Use the
knob
or the number keys to set the desired value.
To Output Square Signals
Press
button to call the user interface of Square signal, the Square waveform
parameters can be set by operating the Square setting menu on the right.
The parameters of Square waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Duty. You can operate the menu by using the menu selection buttons on
the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "
To
Output Sine Signals
" on P11.
The frequency range is 1
μ
Hz
～
50MHz; the period range is 20ns
～
1Ms.
12
