6.Communication with PC
not support obtaining an IP address automatically, you should assign a static IP
address. Here we set the IP address to 192.168.1.71.
Figure 6-2: Set the network parameters of the computer
(3)
Set the network parameters of the ultrawave software.
Run the software on the
computer, choose the "Ports-settings" of the "MENU". Set "Connect using" to LAN.
About the IP, the first three bytes is same as the IP in the step (2), the last byte should
be different. Here, we set it to 192.168.1.99. The range of the port value is 0
～
4000,
but the port which under 2000 is always be used, so it is suggested to set it to the
value above 2000. Here, we set it to 3000.
Figure 6-3: Set the network parameters of the ultrawave software
(4)
Set the network parameters of the Waveform Generator
. In the Waveform
Generator, press
Utility
and choose
I/O Setup
, press
F2
to choose LAN, enter the
submenu. Set the
IP
Addr
and the
Port
to the same value as the "Ports-settings" in
the software in step (3). About the setting method, please refer to "
To Set the LAN
" on
P33. After restarting the Waveform Generator, if you can get data normally in the
38
