5.Front Panel Operation
voltage, current and output time. This function allows up to 100 groups of timer
parameters.
In timer status, press the
Set
key to enter/exit timer setting interface of the current mode.
Press the
Mode
key to switch between the corresponding timer setting interface of the
four working mode.
Number Voltage Current Output
time
Channel 2
Editing value
Page number
Channel 1
(same layout as Channel 2)
Figure 5-1 Timer Setting Interface in Independent Mode
The selected parameter will be highlighted.
In Independent mode or Plus-minus mode, press
orange
ON/OFF
key to select the left
parameter area, press
blue
ON/OFF
to select the right parameter area.
Press the
▲
/
▼
key
to change the parameter item.
After selecting the parameter, use the numeric keys to enter a desired value, press the
key to confirm.
Press the
＜
/
＞
key to go to the previous or next setting page.
Note
:
●
If the input value exceeds the rating of current working mode, the system will change it
to the maximum rating automatically after pressing the
key to confirm.
●
In the Plus-minus mode, the values of the Negative and Positive output time remain
consistent, you can set either of them.
5.4.3
Timer Range
Timer range setting denotes that you can set the last number of timer parameter group and
output mode. You can find out the
TimerRng
submenu of system menu only in timer
status. If turn on the timing output, the system will output the pre-set parameters between
0 and the set number at sequence or loop mode.
19
