3
Get started
3
Warning!
•
The in-wall smart plug must be installed and serviced only by qualified
electrical person.
• Do not touch the terminals of the device during the testing.
• Turn off all power supplying this equipment before installing.
• Make sure that the power supply is off before connecting or disconnecting
it to the auxiliary device.
On/Off button
Reset.
Press and hold the On/Off button (Any one of the two) for ten seconds
until the LED indicator flashes three times to restore the smart plug to
default factory settings.
LED indicator
The LED status gives the following information:
LED status
What it means
LED keep flashing
Device has not joined a network.
Steady light
Device has joined a network.
Flashing three times
Return to Factory Settings.
Identify.
Green LED
Device is on.
Red LED
Device is off.
Identify.
Press and hold the On/Off button (Left button control the left
socket, Right button control the right socket) for three seconds until the LED
indicator flashes three times.
On/Off.
Press one time to switch On and Off (Left button control the left
socket, Right button control the right socket)
.
