3.Functions and Operations
2.
Connect the test lead.
Capacitance
Tip:
Please short contact the two feet of an electrolytic capacitor by using a test lead
before measuring the electrolytic capacitor.
3.
Set the range.
Press the Range softkey to set the range. Auto range automatically selects the range
for the measurement based on the input.
Note:
1000 V input protection is available in all ranges.
10% over range for all ranges except 5
0000 μF
range.
If the reading exceeds 505
00 μF
in 5
0000 μF
range, "overload" will be displayed.
4.
Set the relative value.
Press the Rel softkey to turn on or off the relative operation. For relative operation,
the multimeter subtracts the pre-specified value of REL operation from the actual
measurement result and displays the result. See page 28,
Measuring Frequency and Period
When measuring AC voltage or AC current, you can use the dual display function to
obtain the measured signal’s frequency and period (see page 25,
), or press
to measure the frequency or period directly.
This section describes how to configure frequency and period measurements.
Operating Steps:
1.
Enable the frequency/period measurement.
22
