294000.10003 Rev. B
E n g l i s h
7
6.
Release spreader bar from retaining cradle, and the lift is ready for operation.
DISASSEMBLY
1.
Lower the mast to the lowest possible position, then insert spreader bar into
retaining cradle.
2.
Release leg-locking device (pulling it away from the cast base), close legs tightly
together.
E n g l i s h
294000.10003 Rev. B
6
3.
Lay the Advance flat on the floor (ensure rear castors are securely locked).
4.
Lift the mast assembly upright (using the top of the push handle), and drop the
mast into the slot (1), tighten mast lock knobs (2), release braked castors (3).
SAFETY NOTE–
Avoid trapping fingers. Keep fingers away from the end of the mast when insert-
ing into the mast slot. Tighten the mast-locking device, and unlock the braked
castors at the rear.
5.
Open legs fully. ENSURE leg-locking knob inserts flush against the base casting and
the legs will no longer move freely. The legs will then only operate by the use of the
foot pedal mechanism located at the rear of the base.
