Microstat He Manual
3
Safety Information
Before you attempt to install or operate your system, please make sure that you are aware of all safety precautions listed in this manual
together with the warnings and cautions set out in other documents supplied with the system.
All cryogenic systems are potentially hazardous and you must take precautions to ensure your own safety.
The general safety precautions required when working with cryogenic systems are given in the OINS’ document Safety Matters. We
recommend that all users should read this document, become thoroughly familiar with the safety information provided and be aware of
the potential hazards.
It is the responsibility of customers to ensure that the system is installed and operated in a safe manner. It is the responsibility of customers
to conduct suitable risk assessments to determine the nature and magnitude of hazards.
3.1
Disclaimer
Oxford Instruments assumes no liability for use of any document supplied with the system if any unauthorised changes to the content or
format have been made.
Oxford Instruments policy is one of continued improvement. The Company reserves the right to alter without notice the specification,
design or conditions of supply of any of its products or services. Although every effort has been made to ensure that the information in
this document and all accompanying documents is accurate and up to date, errors may occur. Oxford Instruments shall have no liability
arising from the use of or reliance by any party on the contents of this these documents (including this document) and, to the fullest extent
permitted by law, excludes all liability for loss or damages howsoever caused.
Oxford Instruments cannot accept responsibility for damage to the system caused by failure to observe the correct procedures laid down
in this manual and the other manuals supplied with the system. The warranty may be affected if the system is misused, or the recommen-
dations in the manuals are not followed.
3.2
Disposal and recycling instructions
Before disposing of this equipment, it is important to check with the appropriate local organisations to obtain advice on local rules and
regulations about disposal and recycling.
You must contact Oxford Instruments (giving full product details) before any disposal begins.
3.3
General hazards
The following general hazards must be considered when planning the site for installation and operating the equipment. Please take notice
of the following relevant warnings.
© 2017 Oxford Instruments Nanoscience
MAN-MHE-1.1.0 (28ff3d8) Sep 2017
7
