Maintenance operations
11
4. Checking turnstile units
4.1. Clean turnstile parts from contaminants.
4.2. Check if all the cables are properly connected.
4.3. Check and tighten if necessary thread connections that fasten
turnstile units.
5. Lubricating moving parts of turnstile mechanisms
To get an access to the assemblies, for lubrication of the moving parts of
turnstile mechanisms it is required to:
1. Remove lower decorative board having undone two screws 1
(Fig.6)
2. Remove arms unit - to get this:
2.1. Unscrew fixation lock 2 with box spanner D22
2.2. Loose a screw М8, which is in the hole where the fixation lock
was secured with hexagonal key S6.
2.3. Loose two screws 1 (Fig.4) М8 with hexagonal key S6
2.4. Remove arms unit.
Lubricate the details of the turnstile mechanism (Fig.7) indicated with
numbers 1, 2, 3 and 4.
Lubricating is performed by engine oil of viscosity grade 5W-20 at a rate
of 2 - 3 drops in each slide assembly.
Summary of Contents for Cube C-01
