Cube С-01 turnstile
6
To get an access to all required units of the turnstile it is necessary to
disassemble the turnstile partially. This scope of works includes removal
of the protective backshell. In order to get that done unscrew two screws
(1) and four screws (2), smoothly move the backshell up at a small
distance so that not to break the cable, coming to the indication board (Fig.
2). Disconnect the cable from the indication board.
Move the backshell up to the end and release an access to the swivel
mechanism. The view after removal of the backshell is shown on Fig 3.
Fig.1
Indication
panel
Rotary mechanism
equipped with
control unit
Protective
backshell
Rack
Base
Summary of Contents for Cube C-01
