Installation guidelines
25
Outputs OUT1… OUT3 one can connect to AMCS controller both
directly and via relay. When using relay the diode connection in parallel to
the winding is
mandatory (!)
(Fig. 14).
Fig.14. Connection diagram of diode connected in parallel to
relay winding
Connecting diagram of remote control panel to ACS controller is
shown on Fig.15. In this option the controller controls the turnstile with
the contacts “Left”, “Right” and “Stop”, with “Antipanic” contact
connection and disconnection via the control panel. An important feature
of remote control panel connection via ACS controller is impossibility
of using turnstile modes which are set with button combinations pressed
on the control panel (except for free passage mode at potential control
mode, see Section 5.3 of the Instruction). In this particular case ACS is
responsible for these modes.
Summary of Contents for Cube C-02
